|
|
Hi there.
These are some videos that show some wi-fi basics, shot around 2004 - 2005
How did you like the show?
Report a problem
Reviews:
| Review this podcast |
| Review this podcast |
Episodes
- Cantenna - Calculations
Mon, 08 Jan 2007 17:09:48 +0000
- Screen capture of Linksys WRT54G configuration
Wed, 09 Nov 2005 07:18:40 +0000
A narration explaining how the Linksys WRT54G is configured using the built-in configuration pages.
It is also explained how the various parameters affect the operation of the unit.
- RF Wi-Fi signal splitter
Thu, 03 Nov 2005 06:31:01 +0000
Just like your TV signal splitter, this passive device splits your antenna signal in two.
- RF cables and connectors used in Wi-Fi
Thu, 03 Nov 2005 06:28:33 +0000
A few cables and connectors used in 2.4 - 2.5 Ghz are shown here
- Installing a Wi-Fi PCMCIA card
Thu, 03 Nov 2005 06:19:44 +0000
How to install a wireless Wi-Fi PCMCIA card in your laptop
- Wireless PCMCIA cards and access points (AP)
Thu, 03 Nov 2005 06:17:18 +0000
To connect Wi-Fi to a PC you either need an access point or a PCMCIA card to plug into your PC.
- Integrated patch unit
Thu, 03 Nov 2005 06:11:44 +0000
Some Wi-Fi wireless nodes come integrated as a single unit with the antenna. This shows a patch antenna integrated enclosure.
- Antenna Mounting
Thu, 03 Nov 2005 06:08:35 +0000
This shows you how to mount a wireless antenna to a pole.
- Outdoor installation of a wireless node
Thu, 03 Nov 2005 06:03:59 +0000
This is a step by step HOWTO install a wireless node in the outdoors, with all the drilling, nuts and bolts. By David from the CSIR
- Mesh Networking intro
Thu, 03 Nov 2005 05:03:02 +0000
A whiteboard pictorial introduction to Mesh networking and how it typically would work in a suburb
- Build your own Wireless mesh node
Wed, 02 Nov 2005 16:40:07 +0000
David from the CSIR shows us how to make a Wi-Fi wireless outdoor unit for use in Mesh networking using an off the shelf Linksys WRT54G and a few extra parts. Nice hacking..
- How to make your own Wireless Hotspot
Wed, 02 Nov 2005 16:19:37 +0000
You can make your own wireless hotspot by connecting a Wi-Fi access point via ethernet to a PC that is loaded with the ZoneCD software.
